CA View - 14.0 Install - Is base function ACCEPT BYPASS(HOLDERROR(CC00179)) acceptable?

Products

• Deliver
• View

Issue/Introduction

The client performed the View 14.0 Installation steps out of order, where a receive of HOLDDATA was done before the base function ACCEPT was done. 

The base function ACCEPT fails with:

The ACCEPT of the base functions completes with RC=04 by using:

  BYPASS(HOLDERROR(CC00179))

Is using the BYPASS above for the base function ACCEPT acceptable to do?
Will doing that cause any issues down the road? 

 

Environment

Release : 14.0

Component : CA View

Resolution

It is acceptable to use BYPASS(HOLDERROR(CC00179)) on the ACCEPT on the base.
There will be no issues.