IDMS - Skipping Post Configuration Tasks for products not installed
Article ID: 188465
Updated On:
Products
Issue/Introduction
Is it required to complete the "Post Configuration Tasks" documented for products that are not being declared for use in the Product Intent Module ?
For example:
Issuing DCPROFIL on the CV shows:
* Product Intent Status *
CA IDMS Core Products CA IDMS Tools Products
--------------------- ----------------------
CA ADS YES CA ADS Alive NO
CA ADS Batch NO CA ADS Trace NO
If CA ADS Alive, CA ADS Batch or CA ADS Trace are not being installed, is it okay to skip the Post Configuration Tasks specifically for those products?
Environment
Release: All supported releases.
Component: ADS
Resolution
Yes, it is OK to skip the Post Configuration Tasks for the products that were specified as NO in the IDMS.CAISAG.CONFIG(VARBLIST) member, when CAISAG was run.
CAISAG reads the VARBLIST and generates the configuration jobs for the products that were specified with YES.
So if NO was specified the IDMS.CAISAG.CONFIG(VARBLIST) member for products CA ADS Alive, CA ADS Batch or CA ADS Trace
when CAISAG was run, then YES, it is OK to skip the Post Configuration Tasks for specifically for those products.
Additional Information
Feedback
