Limitation in Output file content seen from WCC

Products

• CA Workload Automation AE - Business Agents (AutoSys)
• CA Workload Automation AE - System Agent (AutoSys)
• CA Workload Automation AE - Scheduler (AutoSys)
• Workload Automation Agent
• Autosys Workload Automation

Issue/Introduction

We see that the output file upon successful job run seems to have lesser content than the actual file seen on the server.

 

Any parameter to change to be able to see the whole content?

 

 

Environment

Workload Automation AE (AutoSys)

Resolution

The LogMaxEndLines parameter defines the maximum number of lines to retrieve from the agent log file or the job log file. You can retrieve these logs either from CA WCC or CA Workload Automation AE.
You can configure this parameter as follows:

UNIX -- Edit the following entry in the configuration file:

$AUTOUSER/config.$AUTOSERV


LogMaxEndLines=value

The value of the LogMaxEndLines parameter can be a number in the range 0 through 10000

Please note:
The default value is 2000. If the LogMaxEndLines parameter is set to 0 (zero), the application server retrieves the entire contents of the agent log file or the job log file.

Setting the parameter to zero is not recommended as the application server might crash. Please refer to the following articles

https://knowledge.broadcom.com/external/article?articleId=44131
https://knowledge.broadcom.com/external/article?articleId=14415

Additional Information

For more details please refer to the product documentation below

https://techdocs.broadcom.com/content/broadcom/techdocs/us/en/ca-enterprise-software/intelligent-automation/workload-automation-ae-and-workload-control-center/11-3-6-SP8/administrating/ae-administration/configure-an-application-server/logmaxendlines.html