Vmware intermittent data collection
Article ID: 188114
Updated On:
Products
DX Unified Infrastructure Management (Nimsoft / UIM)
Issue/Introduction
The instance in the probe always shows like "resource is loading.Please wait"
Vmware probe intermittent data collection issue even though there is no problem with the vcenter connectivity.
Vmware probe intermittent data collection issue even though there is no problem with the vcenter connectivity.
Environment
UIM 8.51 & Later
vmware 7.14 & Later
Vcenter 6.0
Resolution
Please follow the below step:-
=====================
== Go to probe's Raw Configure GUI in the options key under the Startup section.
We typically recommend doubling the values:
-Xms1024m -Xmx2048m
== Check Interval
The check interval defines how often the probe checks the values of the monitors. This can be set in seconds, minutes or hours. vCenter or ESX server system data is updated once per minute. We recommend polling once every 10 minutes. The polling interval should not be smaller than the time required to collect the data.
=====================
== Go to probe's Raw Configure GUI in the options key under the Startup section.
We typically recommend doubling the values:
-Xms1024m -Xmx2048m
== Check Interval
The check interval defines how often the probe checks the values of the monitors. This can be set in seconds, minutes or hours. vCenter or ESX server system data is updated once per minute. We recommend polling once every 10 minutes. The polling interval should not be smaller than the time required to collect the data.
Feedback
Yes
No
Powered by
