ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.
EasyRule command character limit
Article ID: 188080
Updated On:
Products
OPS/MVS Event Management & Automation
Issue/Introduction
When using Easyrule there is a limit of 50 characters for "Operator Commands".
Is there another way to issue longer commands?
Environment
Release : 13.5
Component : OPS/MVS
Resolution
Easyrule has this restriction for the length of the commands (50 characters).
After the rule is created, it can be edited directly at the OPSVIEW panel 4.5.1 to insert the long operator commands.
After the rule is created, it can be edited directly at the OPSVIEW panel 4.5.1 to insert the long operator commands.
Feedback
Yes
No
Powered by
