Clarity PPM - Modern UX - Tasks in "Status" page show numbers without rounding off decimals

Products

• Clarity PPM On Premise
• Clarity PPM SaaS

Issue/Introduction

STEPS TO REPRODUCE:
1. Navigate into the Modern UX and open a project where "Tasks" tab and "Status" tab are both visible
2. Click on "Tasks" tab and display "ETC" column in the grid
3. Display "Include in Status Reporting" column in the grid
4. For a few tasks enter the following as the "ETC" value:
80.43211234
5. Set "Include in Status Reporting" flag to true for the tasks used in Step 4
6. Click on "Status" tab. Click on "Configure" icon. Enable display of "Tasks" section
7. Click on "Configure" icon for "Tasks" section. Display "ETC" column
8. Make note of how decimals are getting displayed in the ETC Column
9. Click on "Preview" button. Make note again of how decimals are getting displayed in ETC column

Expected Result: Numbers are rounded off to 2 decimal places, since that is what is defined in the Attribute settings.
Actual Result: All decimal places that the number was entered with, show up in the Status Reports.

Environment

Version: 15.8.0.

Cause

Defect with ID DE54230.

Resolution

The defect has been fixed in version 15.8.1.