Apply of FAILSAFE getting RC4.

Products

• TLMS Tape Management

Issue/Introduction

Getting a RC4 when I apply the FAILSAFE usermod.

Cause

Getting the following warning messages:

BATCH EMULATOR  JOB(T#TLUSAF) STEP(UMOD    ) PGM= HEWLH096
 IEW2278I B352 INVOCATION PARAMETERS - LIST,LET,NCAL,XREF,RENT,NCAL
 IEW2322I 1220  1            ENTRY IFG019RB                 EXPECT IEW2454W MESSAGES FOR - C
 IEW2322I 1220  2                                           IFG0190P, IFG0194J, IFG0193G,  C
 IEW2322I 1220  3                                           IFG0194A, IFG0195B, IFG0552B
 IEW2322I 1220  4            ORDER IFG019RB
 IEW2322I 1220  5            ALIAS IFG055ZZ
 IEW2322I 1220  6            ALIAS IFG0KLCM
 IEW2322I 1220  7            MODE AMODE(31) RMODE(ANY)
 IEW2322I 1220  8    INCLUDE CTAPLINK(IFG019VM)             CTSUSAF       SEQ # 000001
 IEW2322I 1220  9    INCLUDE LPALIB(IFG019RB)
 IEW2322I 1220  10    NAME IFG019RB(R)                       MAX ACCEPTABLE RC=04
 IEW2454W 9203 SYMBOL IFG0190P UNRESOLVED.  NO AUTOCALL (NCAL) SPECIFIED.
 IEW2454W 9203 SYMBOL IFG0194J UNRESOLVED.  NO AUTOCALL (NCAL) SPECIFIED.
 IEW2454W 9203 SYMBOL IFG0193G UNRESOLVED.  NO AUTOCALL (NCAL) SPECIFIED.
 IEW2454W 9203 SYMBOL IFG0194A UNRESOLVED.  NO AUTOCALL (NCAL) SPECIFIED.
 IEW2454W 9203 SYMBOL IFG0195B UNRESOLVED.  NO AUTOCALL (NCAL) SPECIFIED.
 IEW2454W 9203 SYMBOL IFG0552B UNRESOLVED.  NO AUTOCALL (NCAL) SPECIFIED.

 

Environment

Release : 12.6 and 14.0.

Component : CA TLMS Tape Management

Resolution

This is normal as we are replacing the user exit code with ours. The CSECT's in question are not used/needed.