SYSVIEW PERFORMANCE OPTION FOR DB2 20 - SCM
Article ID: 187476
Updated On:
Products
SYSVIEW Performance Management
NXBRIDGE - SYSVIEW/ENDEVOR
Issue/Introduction
We have both IDB2 and the SYSVIEW OPTION for DB2 installed.
I can see exceptions from IDB2 but I only see 1 warning message if I use SCM from SYSVIEW
I've reviewed the parm members in CAW0OPTN (members IDDCPARM, DB2SSID, INSIGHT, and SCM) and they all look good
I don't know what I'm missing.
I can see exceptions from IDB2 but I only see 1 warning message if I use SCM from SYSVIEW
I've reviewed the parm members in CAW0OPTN (members IDDCPARM, DB2SSID, INSIGHT, and SCM) and they all look good
I don't know what I'm missing.
Environment
Release : 16.0
Component : SYSVIEW
Resolution
The solution was to code the following parm in the SYSVIEW for DB2 data collector parms:
CALL-GSS=YES
CALL-GSS=YES
Feedback
Yes
No
Powered by
