ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.
NTP monitoring components
Article ID: 187254
Updated On:
Products
DX Unified Infrastructure Management (Nimsoft / UIM)
Issue/Introduction
Can we monitor the below two components in UIM using the ntp_response probe:
1. if NTP server name is correct.
2. if Date and Time is accurate.
Environment
Release : 8.51, 9.x
ntp_response
Unified Infrastructure Manager
Resolution
No ntp_response probe cannot monitor the requested components - if NTP server name is correct and if Date and Time is accurate.
Our documentation below describes the QoS metrics that can be configured using the ntp_response probe.
https://techdocs.broadcom.com/content/broadcom/techdocs/us/en/ca-enterprise-software/it-operations-management/ca-unified-infrastructure-management-probes/GA/alphabetical-probe-articles/ntp-response-network-time-protocol-response-monitoring/ntp-response-metrics.html
Our documentation below describes the QoS metrics that can be configured using the ntp_response probe.
https://techdocs.broadcom.com/content/broadcom/techdocs/us/en/ca-enterprise-software/it-operations-management/ca-unified-infrastructure-management-probes/GA/alphabetical-probe-articles/ntp-response-network-time-protocol-response-monitoring/ntp-response-metrics.html
Feedback
Yes
No
Powered by
