Deliver - RMOSTC Started task Failed with S0C4 and will not Start
Article ID: 187219
Updated On:
Products
Issue/Introduction
Deliver RMOSTC started task failed with an SOC4-10 condition.
IEA995I SYMPTOM DUMP OUTPUT 275
SYSTEM COMPLETION CODE=0C4 REASON CODE=00000010
TIME=09.03.00 SEQ=02730 CPU=0000 ASID=0153
PSW AT TIME OF ERROR 078C2000 A90FF04E ILC 6 INTC 10
ACTIVE MODULE ADDRESS=00000000_290F9000 OFFSET=0000604E
NAME=RMOCPTM
DATA AT PSW 290FF048 - 4780C0BA 1A57D500 503080D3
AR/GR 0: 009FC6A4/29F40000 1: 00000000/00000000
2: 00000000/29138000 3: 00000000/FFFFFFFE
4: 00000000/29138060 5: 00000000/2CD11000
6: 00000000/00000000 7: 00000000/29111000
8: 00000000/0000FD18 9: 00000000/28F2F158
A: 00000000/000062B8 B: 00000000/29106B00
C: 00000000/290FEFDC D: 00000000/291069F0
E: 00000000/00000000 F: 01000002/00000000
END OF SYMPTOM DUMP
*RMOSEP30 ********************************************
*RMOSEP30 * *
*RMOSEP30 * DELIVER (RMOSTCX /STCNNNNN) *
*RMOSEP30 * PRODUCT HAS ABENDED WITH CODE S0C4 *
*RMOSEP30 * *** RESTART PRODUCT ASAP *** *
*RMOSEP30 * *
*RMOSEP30 ********************************************
IEF450I RMOSTCX RMOSTCX - ABEND=S0C4 U0000 REASON=00000010
Resolution
Problem occures in module RMOCPTM, with a S0C4-10 condition, indicates a possible corruption of the Deliver Checkpoint file.
Below are the suggested steps to fix this error:
. Run a backup of the checkpoint file (using IEBGENER with output DCB=(RECFM=F,LRECL=4096,BLKSIZE=4096).
. Runn a RMODBASE MAKECKPT EMPTY.
After completing the above steps, RMOSTC task was able to start successfully.
Feedback
