ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.
Incorrect Utilization average in/out value for interfaces if compare NFA with CAPC
Article ID: 186826
Updated On:
Products
CA Network Flow Analysis (NetQos / NFA)
Issue/Introduction
The Trend metric Utilization In and Out average is showing different information for all the interfaces if we compare NFA with CAPC
Cause
This is normal behavior
Environment
Release : 10.0
Component : NQRPTA - REPORTERANALYZER
Resolution
You cannot to compare PM with NFA reports
The NFA Reports show only Flows that were configured and sent by device to NFA Harvester and these Flows are presented graphically
The PM Trend Report shows the total consumption of interface that include Mult-variables
The NFA Reports show only Flows that were configured and sent by device to NFA Harvester and these Flows are presented graphically
The PM Trend Report shows the total consumption of interface that include Mult-variables
Feedback
Yes
No
Powered by
