Renaming calendar event causes error when same name is referenced by GROUP or OFFSET event

book

Article ID: 186267

calendar_today

Updated On:

Products

CA Automic Workload Automation - Automation Engine CA Automic Workload Automation - Automation Engine

Issue/Introduction

An error message is shown when you try to save a CALE-Object after renaming a calendar event, in case a calendar event of the same name (but in a different calendar) is referenced by a group event.

Steps to reproduce:

  1. create Calendar with name CALENDAR1

  2. in CALENDAR1 create event (type weekly) for Monday and name it as MONDAY

  3. create Calendar with name CALENDAR2

  4. in CALENDAR2 create event (type weekly) for Monday and name it as MONDAY

  5. in CALENDAR2 create event (type weekly) for Tuesday and name it as TUESDAY

  6. in CALENDAR1 create event (type group) with name MONDAY_AND_TUESDAY and add event Tuesday and Monday from calendar CALENDAR2 

  7. rename calendar event MONDAY to MONDAY1 in CALENDAR1

  8. click 'Save'

  9. get error message "Calendar: 'CALENDAR1' cannot be calculated or can only be partially calculated due to calendar events with invalid states or to broken links (caused by renamed/deleted calendar events or by imported calendars). The affected calendar events have been sent to the message window, message ID: 11882."

The issue affects versions 12.1, 12.2 and 12.3.





 

Environment

Release : 12.1, 12.2 and 12.3

Component : AUTOMIC WEB INTERFACE

Resolution

Workaround: go into the GROUP or OFFSET calendar event(s) and undo the renaming before saving the calendar


A fix to this issue will be provided for the different releases with the service packs listed below:

  • Automic.Web.Interface 12.3.3 - available since June 29th, 2020

  • Automic.Web.Interface 12.2.6 - available since June 15th, 2020

  • Automic.Web.Interface 12.1.8 - available since May 8th, 2020