ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.
UIM - Maintenance schedules times are wrong after end of Daylight Saving
Article ID: 186030
Updated On:
Products
NIMSOFT PROBES
DX Unified Infrastructure Management (Nimsoft / UIM)
Issue/Introduction
This articles describes a known issue and fix for maintenance schedules starting/ending at incorrect times, after Central European Summer Time (DST) changed to Central European Time.
Environment
UIM 9.2.0
maintenance_mode v9.20
Component : UIM MAINTENANCE
maintenance_mode v9.20
Component : UIM MAINTENANCE
Resolution
This product defect has been resolved in maintenance_mode-9.20-HF2.zip hotfix package.
Steps to apply the patch:
1. Import the zip into the local archive.
2. Deploy the imported package to the primary hub robot system.
Note: Take a backup of the probe cfg before making any changes.
This package and release notes are available on the CA Unified Infrastructure Management Hotfix Index or contact Support, if you have any questions.
https://techdocs.broadcom.com/us/product-content//recommended-reading/technical-document-index/ca-unified-infrastructure-management-hotfix-index.html?r=2
Steps to apply the patch:
1. Import the zip into the local archive.
2. Deploy the imported package to the primary hub robot system.
Note: Take a backup of the probe cfg before making any changes.
This package and release notes are available on the CA Unified Infrastructure Management Hotfix Index or contact Support, if you have any questions.
https://techdocs.broadcom.com/us/product-content//recommended-reading/technical-document-index/ca-unified-infrastructure-management-hotfix-index.html?r=2
Feedback
Yes
No
Powered by
