Vpn Post Discovery Starting and Ending
Article ID: 182915
Updated On:
Products
CA Spectrum
Issue/Introduction
I noticed the following messages in vnm.out
VPN Post Discovery Starting
VPN Post Discovery Ending
VPN Post Discovery Starting
VPN Post Discovery Ending
Environment
Release : 10.x
Component : Spectrum Core / SpectroSERVER
Resolution
These are normally debug messages related to VPN Discoveries:
https://techdocs.broadcom.com/content/broadcom/techdocs/us/en/ca-enterprise-software/it-operations-management/spectrum/10-2/managing-network/mpls-vpn-manager/discovering-and-modeling-vpns/run-vpn-discovery.html
Unless these messages are accompanied by excessive resource utilization, they can be ignored.
https://techdocs.broadcom.com/content/broadcom/techdocs/us/en/ca-enterprise-software/it-operations-management/spectrum/10-2/managing-network/mpls-vpn-manager/discovering-and-modeling-vpns/run-vpn-discovery.html
Unless these messages are accompanied by excessive resource utilization, they can be ignored.
Feedback
Powered by
