HOW TO: Enable GroupWise Plug-in for PGP Desktop 10

book

Article ID: 180261

calendar_today

Updated On:

Products

Symantec Products

Issue/Introduction

 

Resolution


This article provides instructions on how to enable the PGP plug-in for GroupWise.

 NOTE: This article is applicable only if you are running a version earlier than Symantec Encryption Desktop 10.3.1 and Symantec Encryption Management Server 3.3.1. Starting from Symantec Encryption Desktop 10.3.1 and Symantec Encryption Management Server 3.3.1, the PGP plug-in for GroupWise is disabled by default.

 

 

In PGP Desktop 10.0, the PGP plug-in is disabled by default. If you are using the GroupWise 6.5.1 with the proprietary protocol, you will not have automated messaging functionality. However, you can use the PGP GroupWise plug-in that which provides limited functionality for encrypting plain text emails and attachments.

Note: If you are using GroupWise 6.5.1 with a POP/IMAP/SMTP protocol, the PGP Messaging proxy is supported with PGP Desktop 10.0.

Windows XP

  1. Click Start>Run.
  2. Type cmd and click OK.
  3. Type cd\windows\system32 then press Enter.
  4. Type regsvr32 pgpgw.dll /u press Enter. The PGP plug-in for GroupWise plug-in is disabled.
  5. Click OK and type exit then press Enter.

Windows Vista & Windows 7

  1. Click Start.
  2. Type cmd in the Start Search field and click the cmd result in the Programs list. A command prompt window is displayed.
  3. Type cd\windows\system32 then press Enter.
  4. Type regsvr32 pgpgw.dll press Enter. The PGP plug-in for GroupWise plug-in is disabled.
  5. Click OK and type exit then press Enter.

 

 

Powered by Wolken Software