Mapping control statements to mandates

Products

• Control Compliance Suite Windows

Issue/Introduction

 

Resolution

Mapping control statements to mandates

The Content Studio lets you map multiple control statements to a single mandate or section. When you do so, you tie the mandate to every control statement that is relevant to the mandate. You can also map a single control statement to one or more mandates.

To map one or more control statements to a single mandate

1. In the navigation bar in the lower left corner of the Symantec Content Studio window, click Mandates.

2. Click the mandate or section that you want to map control statements to.

3. Click Statement Mappings.

4. Locate the statement that you want to map to the mandate in the Available Statements table and do one of the following:

   • Click the statement, then click the up arrow icon to map it to the mandate.

   • Click the statement and drag it to the Mapped Statements table.

5. Click Save.

To remove a mapped control statement from a mandate

1. In the navigation bar in the lower left corner of the Symantec Content Studio window, click Mandates.

2. Click the mandate or section that you want to remove the mapped control statements from.

3. Click Statement Mappings.

4. Locate the statement that you want to remove from the mandate in the Mapped Statements table and do one of the following:

   • Click the statement, then click the down arrow icon to remove the mapping to the mandate.

   • Click the statement and drag the statement to the Available Statements table.

5. Click Save.

To map a single control statement to one or more mandates

1. In the navigation bar in the lower left corner of the Symantec Content Studio window, click Statements.

2. Click the control statement that you want to map to one or more mandates.

3. Click Mandate Mappings.

4. Click All Mandates to display the list of mandates in the Content Studio.

5. Select a mandate the control statement should be mapped to, and click the add icon with the yellow plus (+) symbol.

   The added mandate sections are shown grouped by mandate in the Mapped Sections area.

To remove one or more mandates from a single control statement

1. In the navigation bar in the lower left corner of the Symantec Content Studio window, click Statements.

2. Click the control statement that you want to remove one or more mandates from.

3. Click Mandate Mappings.

4. Click All Mandates to display the list of mandates in the Content Studio.

5. Select a mandate to remove, and do one of the following:

   • Click the remove icon with the red X symbol.

   • Drag the mandate from the Mapped Sections area to the All Mandates area.

Creating a custom mandate

Creating custom control statements

Mapping policies to control statements

Mapping checks to control statements

Mapping questions to control statements