How to perform the Setup Wizard

Products

• Messaging Gateway

Issue/Introduction

 

Resolution

How to proceed with the Setup Wizard for Messaging Gateway (SMG):

1. Access the web interface of the SMG Control Center by going in a browser to, "https://<IP of SMG Control Center>"
2. Read and accept the End User License Agreement, check the box and click Next.
3. Browse to the license file for SMG. You can locate this file by logging into your mysupport.symantec.com portal.
4. Click "Register License". Then click Next.
5. Add an email address for the admin account. Optionally enable alerts to be sent to this address.
6. Optionally, set the time on the appliance or add NTP servers, click Next.
7. Optionally change the System locale or encoding, click Next.
8. Select, Inbound mail filtering, click Next. (You can make changes to this configuration later in the control center interface)
9. Select the IP address and port for Inbound mail filtering and click Next.
10. Select "All IP addresses" and click Next.
11. Add an IP address to route email to after scanning (your downstream mail server) You will be able to add alternate mail routes once you complete the setup wizard.
12. Select "Use default MX lookup" and click Next.
13. Add a domain to the Local Domains and optionally specify a route other than the email server you specified in step 11.
14. Verify the configuration and click Finish.