KNOWN ISSUE: RDeploy file path invalid error received when an image has previously been modified with file exclusions in Image Explorer.

Products

• Deployment Solution

Issue/Introduction

"RDeploy file path invalid" received at the end of imaging (deploy job)

Steps to duplicate:

1) Create an image on a system

2) Open the image with Image Explorer and set file exclusions

3) Deploy the Image.  The client will load WinPE and proceed with the imaging task.  The job will
progress to approximately 99%, then the transfer window will abruptly close.  The client will hold at the main automation splash screen with the DAgent
reporting the session has been closed.  The job status within the Win32 console will report a task failure, with the following error:

Task: Deployed disk image
Completed: x/xx/xxxx x:xx:xx AM
Module: RDeploy
Level: Error
Status: RDeploy: The file path is invalid.
Result: Failed (Status code: 92)

The RDlog will show the following:

[Start log]
Error description:
     The file path is invalid.
     (Note: Current volume is NTFS from source slot 1.)

Possible causes:
     A file that was expected to exist does not exist.

Possible resolutions:
     Make sure the file exists and is accessible.
     If the missing file is part of this program, reinstall the program

Cause

 

Resolution

The issue was fixed by skipping removed directories when trying to resolve paths of updated files.  The fix is included in DS 6.9 SP3.  Please read the release notes for download and installation instructions.

Applies To
Deployment Server 6.9 SP1 and SP2