Error: "11030 Message: Invalid source drive" or '"11030: Invalid Destination Drive" in automation

Products

• Deployment Solution
• Ghost Solution Suite

Issue/Introduction

System drive not detected in Automation environment (WinPE).

Ghost may throw an errors similar to the following:

Error Number: 11030 Message: Invalid source drive

Usage Error 11030: Invalid Destination Drive

ErrorMessage: ClientImageDeployException occured 'Child Process returned an error', return code 1, system error 'The system cannot find the file specified (0x00000002)', location 'Tcube_ClientImageDeploy.cpp1078'

Environment

DS 8.x

GSS 3.x

WinPE 10

Cause

Most Dell, and some HP computers ship from the OEM manufacturer with RAID enabled in the storage controller. The needed RAID driver for the storage controller is likely not included in WinPE 10. Some RAID drivers are available with WinPE 11.

Resolution

Either locate a matching storage controller driver and import it into the preboot config (PXE, Automation Folder, USB Boot disk) or change the storage controller from RAID to AHCI in the BIOS before capturing/deploying the image.

If the storage controller is changed from RAID to AHCI enabled for a capture image task/job, it will need to be changed back to RAID after the image is captured or the endpoint will not boot to Windows.

Any machine that the AHCI based image is deployed to will also need to be changed to AHCI before booting into automation.

Installing WinPE 11 (if supported) may also be a solution to this issue