search cancel

Change path on FTP Access Log with Command Line

book

Article ID: 173977

calendar_today

Updated On:

Products

Advanced Secure Gateway Software - ASG ProxySG Software - SGOS

Issue/Introduction

Customer attempts to change the path for an FTP Access Log in Management Center, but after applying the change, the path remains the same or is not displayed.

This is discover by visual inspection, no error message is displayed.

Cause

Likely, this issue is caused by using special characters in the path.

Environment

This was tested on SGOS 6.7.3.14 and 6.7.4.3

Resolution

Use the Command Line Interface (CLI) to set the path:

  1. show access-log
  2. conf t
  3. access log
  4. edit log main
  5. ftp-client primary path {PATH.EN_US}
     

To blank out the FTP path use (two quotes with nothing in between):

  1. ftp-client primary path ""