Receiving a system error in the Gantt when adding a new task with in-line edits while Milestone is configured on the view

Article Id: 17366
Status: Published
Updated On: 14-02-2018 08:05
Legacy Id: TEC617806
Products:
CLARITY PPM FOR ITG , Clarity PPM On Premise , CLARITY PPM FEDERAL , Clarity PPM SaaS , Clarity PPM SaaS - Application , Clarity PPM SaaS - Application , Clarity PPM On Premise
Issue/Introduction:

Description:

Steps to Reproduce:

  1. Go to a project with Tasks and open the Gantt
  2. Put a check in the checkbox next to the last task and press the Insert key on your keyboard
  3. Enter task name and tab to Start Date and change date using the date picker
  4. Tab to Finish Date and again use date picker to select a date
  5. Click the Save icon in the upper left hand corner of the Gantt
  6. Now configure the view to have the Milestone column in the view
  7. Repeat steps 2 to 5

Expected Result: New task saves without any error 

Actual Result: System Error
Workaround: Add the Task using the green Add New Task icon

Solution:

This has been resolved in 14.2 as CLRT-75761.

Environment:

Release: ESPCLA99000-13.3-Clarity-Extended Support Plus
Component: