search cancel

WSS Application control rules

book

Article ID: 173516

calendar_today

Updated On:

Products

Web Security Service - WSS

Issue/Introduction

You want to write a policy to control application actions in Web Security Service (WSS) portal

Environment

You use any WSS access method and WSS portal tenant this method does not take into account UPE (Universal Policy Enforcement) 

Resolution

  1. In the WSS portal, navigate to Policy > Content Filtering 
  2. You can choose to edit an existing rule or Add Rule.
  3. To set up, Application control uses the Destination and Content and Limits section at a minimum but you can add other fields too.
  4. In the Destination, section click on Add Destinations.
  5. Choose Web Application and choose the application from the list on the left pane. The list is quite large so you can use the search bar to find the application you want.
  6. After you have found the desired application click on the ">" button and then hit Save.
  7. The next Step is to click on Content and Limits and click on Actions.
  8. Once again search to locate the action you require for the rule.
  9. Once you have selected the action use the ">" to move it to the pane on right and hit Save.
  10. Finally, click on Save Rule and Activate to install the policy.