In Software Management version 8.1 RU5 new option: "Continue job if component is not applicable" doesn't work

Article Id: 171020

Status: Published

Updated On: 14-02-2018 06:38

Legacy Id: TECH249289

Products:

Software Management Solution

Issue/Introduction:

In Software Management version 8.1 RU5 new option: "Continue job if component is not applicable" doesn't work if Abort is selected under the Actions after termination or failure options in Advanced options.

Cause:

This user interface option was inadvertently added in 8.1 RU5, however the code behind it will not be available until the 8.5 release.

Resolution:

As this option is non-functional, if you need a policy to run other software tasks choose Continue as the Actions after termination or failure: Action option. This will not allow a non-detected applicablility rule to stop the entire policy.