ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.
Management Center SNMP configured but not listening
Article ID: 170962
Updated On:
Products
Management Center
Issue/Introduction
SNMP settings have been configured, but an SNMP walk from a remote server is not working.
Resolution
SNMP remote read access is disabled by default. This can be enabled from the CLI:
- SSH to Management Center
- Enter enable mode
- To enable snmp read access, use the command: snmp enable-remote-read-access
This change will not be reset after a reboot. If you wish to disable it, you can use the command: snmp disable-remote-read-access
Feedback
Yes
No
Powered by
