Create a user with read only access

book

Article ID: 170409

calendar_today

Updated On:

Products

Advanced Secure Gateway Software - ASG SG-300 SG-S500 SG-S400 Secure Web Gateway Virtual Appliance SG-S200 ProxySG Software - SGOS SWG VA-100

Issue/Introduction

You need to create a user with read only access.

Resolution

Follow the steps below to create a user with read only access:

1. Add a User list and name from the Proxy CLI:

SGOS#(config) security local-user-list create list name
SGOS#(config) security local-user-list edit list name
SGOS#(config local-user-list list name) user create username
SGOS#(config local-user-list list name) user edit username
SGOS#(config local-user-list list name) username password password

2. Create a local realm in GUI:

Configuration -> Authentication -> Local -> New realm name
Under Local Main tab, select list name under Local user list from drop down menu

3. Create Admin Authentication layer in VPM:

Source ->any
Action -> AdminAuthenticate in Local Realm

4. Create Admin Access Layer in VPM:

Create Admin Access Layer in VPM:
Source -> User, Authentication -> Local Realm
Service -> HTTS-console
Action -> Allow read only Access

Add a rule on this layer for user Admin, Local Realm and Allow read/write access.