ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.
Can Advanced Threat Protection's Inline interfaces both be on the same subnet?
Article ID: 169947
Updated On:
Products
Endpoint Detection and Response
Advanced Threat Protection Platform
Issue/Introduction
Can the Advanced Threat Protection 8880 appliance with dual Inline scanning interfaces be configured where both Inline interfaces are on the same subnet?
Example:
Inline1 IP: 10.10.12.25
Inline2 IP: 10.10.12.225
Resolution
This configuration is not supported on the Advanced Threat Protection 8880 appliance. Each Inline and Management interface needs to be on separate subnets. As of ATP 2.3, the web interface will allow you to configure both Inline interfaces on the same subnet, but there will be unintended consequence if they are configured this way and it is not supported.
Feedback
Yes
No
Powered by
