Resolving "No Boot Device Found" error when trying to install a new version of Security Analytics
book
Article ID: 169103
calendar_today
Updated On:
Products
Security Analytics
Issue/Introduction
This has been seen on new installations during the first boot. This is usually caused by improper configuration in the BIOS.
Resolution
- Boot the system and when prompted by the message, press F2. This should appear during the first few minutes of power up. F2 is for System BIOS.
- Select Boot Settings
- If the Boot Mode is UEFI, it needs to be changed. Select Boot Mode BIOS.
- Check that the Boot Sequence specifies Hard Drive C:
- Press ESC to exit and select Yes when prompted to save.
After a reboot the appliance should be able to find the correct boot strap.
Feedback