ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.
How does SSL Visibility Appliance Fail-to-wire Auto recovery option work?
Article ID: 169010
Updated On:
Products
SSL Visibility Appliance Software
Issue/Introduction
If an interface on the SSL Visibility appliance goes down, the appliance will go into failure mode. If the interface comes back up and bounces within five seconds of recovery, the box will remain in failure mode and will not recover unless it is manually recovered.
Feedback
Yes
No
Powered by
