ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.

Why does the Command Line Interface not display all the event-log lines for the ProxySG appliance?


Article ID: 168819


Updated On:


ProxySG Software - SGOS


When you type the show event-log command in the Command Line Interface (CLI) to view the event logs, the CLI displays fewer event-log lines than the Management Console does for the same ProxySG appliance.


The default settings for SGOS limit the number of event-log lines you see when you view the event log in the CLI.


To view the entire event log in the CLI, while in privileged mode, type the following commands:

ProxySG#(config)reveal-advanced hidden
ProxySG#(config)show event-log severity 0xFFFFFFFF

Note: The first command is a hidden command that allows the CLI to display hidden elements. The second command sets the CLI to accept the event log severity display level.