ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.
MC-S400 appliance onboard NIC port LEDs fail to get link and activity lights
Article ID: 168675
Updated On:
Products
Management Center
Issue/Introduction
SYS:MGMT (0:0) is the only port that shows link and activity LEDs:
Issuing the verify-hardware CLI command displays the presence of all onboard NIC ports, but only the SYS:MGMT establishes a connection:
Cause
On MC-S400 appliances, SYS:MGMT is the ONLY port that is currently enabled.
NOTE: Ports 1:0, 2:0 and 2:1 are not enabled at this time.
NOTE: Ports 1:0, 2:0 and 2:1 are not enabled at this time.
Resolution
Please use the SYS:MGMT port to configure and access the MC-S400 appliance.
Attachments
Feedback
Yes
No
Powered by
