PacketShaper S-series does not load new image after upgrading

Products

• PacketShaper S-Series

Issue/Introduction

After upgrading, the PacketShaper S-series is booting the previous version.

After installing a new image with the setup image add file command, the PacketShaper indicates "Image upgrade successful. Please reset to activate new image." 

However, after resetting PacketShaper, it does not boot up the newly installed image.
 
The installed image is not listed in the output of setup image show.

Cause

This upgrade problem is related to an incorrectly set date on PacketShaper.

 

Resolution

To see the current system date, use the date CLI command. To modify the date, use the setup date <yyyymmddhhmm> command.