WCCP service-group password that leads with a number results in configuration error
book
Article ID: 168221
calendar_today
Updated On:
Products
Asset Management SolutionProxySG Software - SGOS
Issue/Introduction
When setting the service-group password in the Management Console GUI, if the password starts with a number, the proxy SG will report the error when committing the change:
"Password cannot begin with a number"
However, if you set the same password starting with a number in the CLI, the proxy SG will accept the password.
Cause
This is a bug in the Management Console GUI. The proxy should accept service-group passwords that start with a number.
Resolution
This issue is addressed in SGOS 6.5.5.5 and later.