ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.

Can you modify speed and duplex settings on the SSL Visibility Appliance?


Article ID: 168180


Updated On:


SSL Visibility Appliance Software


Speed and duplex settings cannot be modified on any of the SSL Visibility Appliance's interfaces.


All SSL Visibility Appliance interfaces are configured as auto/auto by default.

As a result, forcing a Gigabit port to 100/Full will cause the Dashboard to indicate that the interface was set to 100/Half. If a 100 Mb connection is required, the SSL Visibility Appliance must be connected to a 100 Mb port.