ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.
Error: "This machine has no SGOS systems" after replacing 3V battery on SG9000
Article ID: 168170
Updated On:
Products
SG-9000
Issue/Introduction
The first time a SG9000 is powered up after replacing the 3V battery the following messages will be displayed:
Resolution
To resolve this issue it is necessary to use the power button on the front off the system to turn the SG9000 off and back on again.
Power cycling the SG9000 appliance using the front power button is only required one time after the 3V battery is replaced.
After powering on the SG9000 using the front power button, the appliance will boot normally for any subsequent restarts.
1) Flip the front panel (bezel) down to access the front power button.
2) Press the power button to turn the appliance off and then back on again.
Attachments
Feedback
Yes
No
Powered by
