Check Point has published information regarding the versions of the CPInfo utility used by Check Point for troubleshooting. The CPInfo utility must be downloaded from the Check Point Web site. Use the correct version of CPInfo for your firewall version.
Solution ID: sk35746
CPinfo for Crossbeam OS
Product: Security Gateway, CPInfo
Version: NGX R60, NGX R61, NGX R62, NGX R65, R70
Last Modified: 24-Dec-2008
Solution
1. Obtain the latest CPinfo utility from the Check Point Support site.
Since Crossbeam is based on Linux, refer to:
* CPInfo NGX for SecurePlatform and Linux 3.0
* CPInfo NG AI for SecurePlatform and Linux 2.2
For a non-VSX installation, run the
fw ver command in the command line.
If you see “NGX” in the output, refer to CPInfo NGX for SecurePlatform and Linux 3.0. Otherwise, refer to CPInfo NG AI for SecurePlatform and Linux 2.2 .
For VPN-1 VSX refer to CPInfo NG AI for SecurePlatform and Linux 2.2.
For VPN-1 Power VSX NGX R65, refer to CPInfo NGX for SecurePlatform and Linux 3.0.
2. Refer to the “Linux/SecurePlatform” section in sk30567 for installation instructions.
Workaround
N/A