How to change the fail mode on Imperva blade running on Crossbeam platform?
book
Article ID: 167880
calendar_today
Updated On:
Products
XOS
Issue/Introduction
How to change the fail mode from fail-open to fail-close or vice versa on Imperva blade running on Crossbeam platform?n/a
Cause
Q1. Can the fail mode be changed on the fly on Crossbeam platform similar to Imperva gateways running on other non-Crossbeam platforms,
Q2. Customer is inquiring how to change the "fail mode" on Imperva gateways running on Crossbeam via the MX GUI ?
Resolution
A1. On Crossbeam platform, the fail mode cannot be changed on the fly for Imperva Gateways running on Crossbeam platform. A2. During the initial configuration, if you tell the Imperva GUI that you are working on a Crossbeam appliance, it will let you choose one: fail close or fail open. However, on a Crossbeam appliance to switch the fail-mode, you have to create another gateway group and pick the different option.