Unable to establish WCCP with Cisco Nexus switches

book

Article ID: 167050

calendar_today

Updated On:

Products

ProxySG Software - SGOS

Issue/Introduction

Unable to establish WCCP with Cisco Nexus switches

1. WCCP State shows Assignment Type Mismatch

2. WCCP State shows Service Group Mismatch although the Service Group numbers were configured correctly.

Resolution

1. It has been observed that the Cisco Nexus switches might not support the WCCP Hash Assignment Type. Try changing the WCCP Assignment Type to Mask on the ProxySG.

KB4911_1

 

2. If the WCCP State shows a "Service Group Mismatch", try adding "service-flags source-ip-hash" into the WCCP configuration via the Text Editor. If this does not fix the problem, obtain a packet capture and compare the Flags in the WCCP Service Info section and configure the ProxySG to match the flags required by the Nexus switch.

kb4911_2

Attachments