My ProxySG appliance is down. The Power LED is Amber and the HDD LEDs are green. What can I resolve this problem?

Products

• SG-600
• SG-510
• SG-810
• SG-9000
• SG-900

Issue/Introduction

The ProxySG appliance does not boot or display any console output after powering on the appliance. The appliance front panel LEDs display following:

• Power LED is Amber
• HDD LED is Green

 

Resolution

Before initiating an RMA, please try to rule out if it might be a disk issue by performing the following steps (this only applies to multi-disk systems):

The following is an example of a ProxySG appliance with 2 disks

1. Remove disk 2 and attempt to boot the appliance using only disk 1. If the problem persists, please continue to step 2.
2. Remove disk 1 and attempt to boot using only disk 2. If the problem persists, please contact Blue Coat Technical Support to initiate a RMA of the system.
3. In the event that one of the above steps results in the ProxySG appliance coming back up, please contact Blue Coat Technical Support to initiate a RMA of the problematic disk.