Backup PacketShaper Configuration using Web Interface
Article ID: 166280
Updated On:
Products
PacketShaper
Issue/Introduction
Process to Backup PacketShaper Configuration using Web Interface
Resolution
Use the following procedures to back up the PacketShaper configuration through the Advanced User Interface.
1) Log into the PacketShaper.
2) Click on Advanced UI.
3) Go to the Info tab.
4) Click on quick commands. The Quick CLI commands window opens.
5) Select the checkbox Enable any CLI Command.
6) Type one or both of the commands below to back up the PacketShaper configuration:
setup capture complete backup.cmd
config save 9.258/backup.ldi
Feedback
Yes
No
Powered by
