How does the "Send partial buffer after N seconds" option interact with an Access Log's Upload Schedule?
Article ID: 165934
Updated On:
Products
Issue/Introduction
How does the "Send partial buffer after N seconds" option interact with an Access Log's Upload Schedule?
The option is found in the Configuration Tab -> Access Logging -> Logs -> Upload Client.
How does that interact with the Configuration Tab -> Access Logging -> Logs -> Upload Schedule section?
How does the "Send partial buffer after N seconds" option interact with an Access Log's Upload Schedule?
Resolution
The setting referred to above is only valid under the following circumstances:
1.) Continuous upload method is selected
2.) The file type is text.
If using a periodic upload or a gzip upload, then the time interval set in the "Send partial buffer after N seconds" is not honored.
NOTE: The continuous upload method is found by going to the Management Console (https://ip.address.of.sg:8082) Configuration tab > Access Logging > Logs > Upload Schedule. You will change it from periodic to continuous. If this is set to periodic and you have continuous uploads, please see Article ID: 165321 titled "Access logs start unwanted early uploads or small log files are constantly uploading".
Feedback
