How can I see the active HTTPS connections to the PacketShaper GUI?

Products

• PacketShaper

Issue/Introduction

To view the number of active HTTPS management access sessions to PacketShaper, you can use the command setup https show  as shown below.

 

PacketShaper# setup https show

HTTPS service is listening on port #: 443 (default)

 

Certificate Information:

Thumbprint(SHA1)=76:82:19:00:03:A9:BA:34:8A:7D:C9:AB:BD:33:2C:4E:A2:DB:15:AF

Fingerprint(MD5)=83:4C:5C:19:3F:D2:43:7D:A2:96:4B:DB:09:61:07:83

active HTTPS conn 0 IP 192.168.1.1 allocated 874910

open 0 seconds

Idle times: read 0 write 0 secread 0 secwrite 0

active HTTPS conn 1 IP 192.168.1.1 allocated 874906

open 4 seconds

Idle times: read 0 write 2 secread 2 secwrite 0

active HTTPS conn 2 IP 192.168.1.1 allocated 874909

open 1 seconds

Idle times: read 0 write 0 secread 0 secwrite 0

active HTTPS conn 5 IP 192.168.1.1 allocated 874909

open 1 seconds

Idle times: read 0 write 0 secread 0 secwrite 0

active HTTPS conn 6 IP 192.168.1.1 allocated 874909

open 1 seconds

Idle times: read 0 write 0 secread 0 secwrite 0

active HTTPS conn 7 IP 192.168.1.1 allocated 874909

open 1 seconds

Idle times: read 0 write 0 secread 0 secwrite 0

No stale HTTPS connections; all currently active or uninitialized

No active or stale HTTP connection resources

SSH service is listening on port 22

Active SSH connection index 0 client 10.155.0.185

 

Note: This feature requires "showdebug" system variable to be turned on with the command "sys set showdebug 1"