Configuring a protocol to use a specific log facility

Products

• ProxySG Software - SGOS

Issue/Introduction

Configuring a protocol to use a specific log facility
You want to configure a protocol to use a specific log facility

Resolution

The following list shows the protocols supported and the default log facilities assigned to them, if any:

• Endpoint Mapper: main
• FTP: main
• HTTP: main
• HTTPS-Reverse-Proxy: main (Set to the same log facility that HTTP is using upon upgrade.)
• HTTPS-Forward-Proxy: ssl (If the facility for HTTP, TCP, or SOCKS is set before upgrade.)
• ICP: none
• Instant Messaging: im
• Peer to Peer: p2p
• Real Media/QuickTime: streaming
• SOCKS: none
• SSL: ssl (If the facility for HTTP, TCP or SOCKS is set before upgrade.)
• TCP Tunnel: main
• Telnet: main
• Windows Media: streaming

To associate a log facility with a protocol from the Management Console go to Configuration > Access Logging > General > Default Logging.

To associate a log facility with a protocol from the CLI, use the following commands:
SGOS#(config) access-log
SGOS#(config access-log) default-logging {epmapper | ftp | http | https-forward-proxy | https-reverse-proxy | icp | im | mms | p2p | rtsp | socks | ssl | tcp-tunnel | telnet}