"ipmi_si ipmi_si.0: Could not set the global enables: 0xcc." message logged on iDRAC console after 2.2 upgrade

Products

• Endpoint Detection and Response

Issue/Introduction

After upgrade to the version 2.2.0-740 following message might be observed on iDRAC console: "ipmi_si ipmi_si.0: Could not set the global enables: 0xcc." in large numbers.

Resolution

This message is just of informational value, it is not a sign of a hardware or software issue. It can be safely ignored.

This issue is resolved in ATP version 3.0 and later.