Issues with job/task functionality when using Default Automation (Auto-select) in GSS 3.x

book

Article ID: 162299

calendar_today

Updated On:

Products

Ghost Solution Suite

Issue/Introduction

When setting up a Create Image or Distribute Disk Image task in Ghost Solution Suite 3.x you may experience the following issues:
  • Create Image tasks may not populate the Additional Parameters box.
  • Distribute Disk Image tasks may not allow selection of the Data transfer mode check box.

Resolution

This issue is currently under investigation.

To work around this issue, select an automation other than 'Default Automation (Auto-select)' in the Automation pre-boot environment drop down list box.