"Strike the F1 key to continue, F2 to run the system setup program" is displayed when booting a physical Symantec Web Gateway

book

Article ID: 160932

calendar_today

Updated On:

Products

Web Gateway

Issue/Introduction

When booting a physical Symantec Web Gateway the message "Strike the F1 key to continue, F2 to run the system setup program" is displayed and physical interaction is required to complete the boot process.

Fan speed may change depending on system configuration and option card installation.

Strike the F1 key to continue, F2 to run the system setup program

Resolution

  1. Press the "F2" key to enter system setup
  2. Arrow down to "F1/F2 Prompt on Error"
  3. Select "Disable"
  4. Press <ESC>
  5. Select "Exit and Save Changes" and press <ENTER>

Applies To

Appliance model 8450

or

Appliance model 8490