ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.
Disabling SSH on a Symantec Network Access Control Enforcer appliance
Article ID: 158949
Updated On:
Products
Network Access Control
Issue/Introduction
Symantec Network Access Control (SNAC) LAN and Gateway Enforcer appliances come with SSH (OpenSSH) enabled for remote access. Can this service be disabled?
Resolution
From the Enforcer appliance command line interface (CLI), the following commands will turn off the SSH service, and prevent it from starting automatically when the device boots.
- console ssh stop
- console ssh off
To verify the current status use the command:
- console show
Feedback
Yes
No
Powered by
