Error: "No default or UI configuration directive found!" when installing linux based product from an .ISO on a bootable disc

Article Id: 158823

Status: Published

Updated On: 02-09-2015 01:26

Legacy Id: TECH213826

Products:

Security Information Manager , Web Gateway , Messaging Gateway

Issue/Introduction:

Installing SSIM, SWG or SMG from an .iso file on a bootable disc or in a virtual environment

The disc boots, but displays the following error before ISO Linux loads:

Error: "No default or UI configuration directive found!" when installing SSIM from an .ISO on a bootable disc

Resolution:

The .iso file is likely corrupt.

Use the provided md5 file to check consistency of the .iso file. It may need to be redownloaded, or recopied to the location it is actually being installed from. Make sure to verify the actual file that is being installed.