This document describes the stopping of the SYSVUSER STC at the same time when stopping the SYSVIEW STC, without entering additional commands. How can we stop SYSVIEW and SYSVUSER with 'P SYSVIEW’ command?
Release: ALL
Component: SYSVIEW
The STOPCMD parmlib member help accomplish this. The STOPCMD member is located in the CA Sysview library prefix.CNM4BPRM. It is possible to use STOPCMD member as follows. Please specify the contents of the')IF JOBNAM=SYSVIEW' statement and others above the ')EOF ' statement as follows;
<Sample>
)IF JOBNAME=SYSVIEW
)IF JOBACTIVE=SYSVUSER
STOP SYSVUSER
)ENDIF
)ENDIF
)EOF