How can I configure "Disk Latency" metrics in the cdm probe?
search cancel

How can I configure "Disk Latency" metrics in the cdm probe?

book

Article ID: 15654

calendar_today

Updated On:

Products

DX Unified Infrastructure Management (Nimsoft / UIM) CA Unified Infrastructure Management On-Premise (Nimsoft / UIM) CA Unified Infrastructure Management SaaS (Nimsoft / UIM)

Issue/Introduction

How can I configure "Disk Latency" metrics in the cdm probe?

Environment

  • cdm 6.60 or later

Resolution

Disk Latency metrics can only be configured for the cdm probe from AdminConsole.

This feature is available from version 6.60 and higher for the cdm probe.

Ensure you have the latest GA release of the cdm probe installed, then from AdminConsole select the Disks node in the left hand column. 

From here you can configure Disk Latency metrics in the monitors section

  • Disk Latency (ms)QOS_DISK_LATENCY 

  • Disk Read Latency (ms)QOS_DISK_READ_LATENCY

  • Disk Write Latency (ms)QOS_DISK_WRITE_LATENCY

 

 

Additional Information

Powered by Wolken Software