Problems using the "Change Format" option within DeployCenter's VF Editor

Products

• Symantec Products

Issue/Introduction

When you open a VFD in VF Editor and change the format of the VFD from 1.44 MB to 2.88 MB, you notice that the VFD immediately reverts back to the 1.44 MB format.

Symptoms
After using the DeployCenter Boot Disk Builder to create a VFD file, you can open that VFD file in VF Editor.

Click Image > Change Format
Change the format from 1.44 MB to 2.88 MB
Click OK

Click Image > Change Format
You will see that the format has reverted back to 1.44 MB.

 

Cause

The cause of the issue is currently unknown.

Resolution

Symantec is aware of this issue with VF Editor and is currently investigating the cause. This KB document will be updated with new information as it becomes available.